Saving Energy; Switching On The Refrigerator; Setting The Temperature - Dometic CRX PRO 0050T Instructions De Montage Et De Service

Using the refrigerator
I
NOTE
• Before starting your new refrigerator for the first time, you should
clean it inside and outside with a damp cloth for hygienic reasons
(please also refer to the chapter "Cleaning and maintenance" on
page 23).
• Do not use force to press the flap of the freezer.
• Do not pull out the dividing wall if there is ice in the freezer.
• Do not remove the control panel membrane when operating the
refrigerator.
8.1

Saving energy

• Only open the refrigerator as often and for as long as necessary.
• Allow warm food to cool down first before placing it in the device to keep cool.
• Defrost your refrigerator as soon as a layer of ice forms.
• Avoid unnecessarily low temperature settings.
• For optimal energy consumption, position the shelves and drawers according to
their position on delivery.
• On a regularly basis, make sure the door seal still fits properly.
• Clean dust and dirt from the condenser at regular intervals.
8.2

Switching on the refrigerator

➤ Switch the refrigerator on by pressing the
I
NOTE
8
After switching on, the refrigerator needs some time before the
compressor starts up.
8.3

Setting the temperature

➤ Press the
button repeatedly until the desired temperature level is set. The
lower/largest LED is the coldest setting. The upper/smallest LED is the warmest
setting. To switch from the coldest level to the warmest level press the
again.
20
CRX PRO 0050T, CRX PRO 0065T
button.
button
EN