Kitchen Timer - Bauknecht BIK9 PPH8TS2 PT CH Guide Rapide

10. TOOLS
Press to open the "Tools" menu at any time. This
menu enables you to choose from several options
and also change the settings or preferences for your
product or the display.
REMOTE ENABLE
To enable use of the Bauknecht Home Net app.

KITCHEN TIMER

This function can be activated either when using a
cooking function or alone for keeping time. Once
started, the timer will continue to count down
independently without interfering with the function
itself. Once the timer has been activated, you can also
select and activate a function.
The timer will continue counting down at the top-right corner
of the screen.
To retrieve or changhe the kitchen timer:
• Press .
• Tap .
An audible signal will sound and the display will
indicate once the timer has finished counting down
the selected time.
• Tap "DISMISS" to cancel the timer or set a new
timer duration.
• Tap "SET NEW TIMER" to set the timer again.
LIGHT
To switch on or off the oven lamp.
SELF-CLEAN
Activate the "Self-Clean" function for optimum
cleaning of the internal surfaces.
It is reccommended to do not open the oven door during the
cleaning cycle to avoid a loss of water vapor that could get an
adverse effect on the final cleaning result.
• Remove all accessories from the oven before
activating the function.
• When the oven is cold, pour 200 ml of drinking
water on the bottom of the oven.
• Tap "START" to activate the cleaning function.
Once the cycle has been selected, you can delay the start of
automatic cleaning. Tap "DELAY" to set the end time as
indicated in the relevant section.
•
DRAIN
The drain function allows the water to be drained in order to
prevent stagnation in the tank. For optimal use of the appliance,
it is advisable to always carry out draining everytime the oven
has been used with a steam cycle.
Once selected the "Drain" function,
press and follow the actions
indicated: Open the door and place a
large jug under the drain nozzle
located at the bottom right of the
panel. Once started the draining,
keep the jug in position until the
operation is completed. The average duration for full load
drainage is about three minutes.
If needed, it is possible to pause the draining process by pressing
BACK or STOP button (for example in case the jug would be
already full of water in the middle of the draining process).
The jug must be at least 2 liters large.
Please note: to ensure that the water is cold, it is not possible to
perform this activity before 4 hours have elapsed from the last cycle
(or the last time the product was powered). During this waiting
time, the display will show the following feedback "WATER IS HOT
- PLEASE WAIT".
• DESCALE
This special function, activated at regular intervals, allows you to
keep the tank and the steam circuit in the best condition.
The message < PLEASE DESCALE > will be shown on display,
to remind you to execute this operation regularly.
Descale requirement is triggered by the number of steam
cooking cycles performed or steam boiler working hours
since the last descale cycle (see the table below).
"PLEASE DESCALE" MESSAGE appears
after
15 cycles of steam cooking
22 hours of steam cooking duration
20 cycles of steam cooking
30 hours of steam cooking duration
The descaling procedure can also be performed whenever the user
desires a deeper cleaning of the tank and the internal steam circuit.
The average duration of the full function is around 180
minutes. Once the function is started, follow all the steps
indicated on the display.
Please note: The function can be paused but, if it is canceled at any
time, the entire descaling cycle must be repeated from the
beginning.
PHASE 1: DRAINING (up to 3 min.)
»
When the display will show <PLACE A CONTAINER UNDER
NOZZLE>, please proceed with the draining task as described in
the dedicated Drain paragraph.
Please note: to ensure that the water is cold, it is not possible to
perform this activity before 4 hours have elapsed from the last cycle
(or the last time the product was powered). During this waiting
time, the display will show the following feedback "WATER IS HOT
- PLEASE WAIT".
The jug must be at least 2 liters large.
» PHASE 2: DESCALING (~120 MIN.)
When display will show <ADD 1.7 L OF SOLUTION>, please pour
the descaling solution in the drawer. We recommend to prepare
the descaling solution adding 3 sachets (corresponding to 75g)
of the specific Oven WPRO* descaler in 1,7 liters of drinking
water at ambient temperature.
EN
WHAT TO DO
Descale is recommended
It is not possible to run a
Steam cycle until a Descale
cycle will be carried out
7