Attaching The Drive Assembly For Tilt-Head Mixers - KitchenAid KICA0WH Instructions

Masquer les pouces Voir aussi pour KICA0WH:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ASSEMBLING THE ICE CREAM MAKER
CMD + SHIFT CLICK TO CHANGE COPY
Attaching the dr_ive assembly for_ Tilt-Head Mixer_s
Be sure the Stand Mixer is still OFF and
1
unplugged. Keep the motor head tilted
back and put the dasher and freeze bowl
into place.
Slide drive assembly onto the motor
3
head until it will not slide any further.
When properly assembled, the outer
curved edges of the drive assembly
should center on the motor head. If
they are not centered, slide the drive
assembly either back or forward until it
is centered on the motor head. Make
sure the drive assembly is securely in
place by pressing upward.
Make sure the motor head is down
5
completely.
Step
No Spring
Determine your mixer model by
2
checking for a spring on the beater shaft,
and then position the drive assembly as
illustrated for proper placement.
Lower the motor head to engage the
4
drive assembly with the dasher. If the
drive assembly doesn't engage the
dasher, slide the drive assembly either
back or forward until it does engage
the dasher properly.
Place locking lever in the LOCK
6
position. Before mixing, test the lock by
attempting to raise the motor head.
No Step
Spring
7

Publicité

Table des Matières
loading

Table des Matières