Important; Maintenance And Storage - Ribimex Ribiland PRW800A Manuel D'instructions Et D'utilisation

6. Place nylon line above the cutting area. Do not make sudden movements.
7. Press on switches (A4) and (A3) to start operation.
8. Once work is finished, stop product by releasing the switch (A4).
Note: do not put down product until the nylon line has completely stopped moving.
I
MPORTANT
T
O PROLONG THE LIFE OF YOUR ENGINE
S
TART AND STOP THE ENGINE BY PRESSING AND RELEASING THE SWITCH GRADUALLY
5.3- Tips - grass trimmer
Working with the Nylon spool line
TRIMMING: This is feeding the trimmer carefully into the material you wish to cut.
Tilt the head slowly to direct debris away from you.
If cutting up to a barrier such as fence, wall or tree, approach from an angle where any debris
ricocheting off the barrier will fly away from you, Move the line head slowly until the grass is cut
right up the barrier, but do not jam (overfeed) the line into the barrier.
If trimming up to a wire mesh or chain linked fence be careful to feed only up to wire. If you go to
far the line will snap off around the wire. Trimming can be done to cut through weed stems one at a
time. Place the trimmer line head near the bottom of the weed-never high up which could cause the
weed to chatter and catch the line. Rather than cut the weed right through, just use the very end of
the line to wear through the stem slowly
SCALPING AND EDGING: Both of these are done with the line head tilted at a steep angle.
Scalping is removing top growth, including roots, leaving the earth bare.
Edging is trimming the grass back where it has spread over a sidewalk or drive way.
During both edging and scalping, hold the unit a steep angle and in a position where the debris and
any dislodged dirt and stones, will not come back towards you even if it ricochets off any hard
surface.
Although the figures show examples of how to edge and scalp, every operator must find for himself
the angles which suits his body size and cutting situation
WARNING! Do not to use a steel blade for edging or scalping
Do not trim in any area where there are strands of fencing wire.
Do not cut where you cannot see what the cutting device is cutting
Adjusting the line length
1. The grass trimmer is equipped with a semi-auto type nylon line head that allows the operator to
advance the line without stopping the engine.
2. When the line becomes short, lightly tap the head on the ground while running the engine at full
throttle.
3 Each time the head is bumped, the line advances about 25 mm.
4. For better effect, tap the head on bear ground or hard soil.
5. Avoid bumping in thick, tall grass or soft ground.
VI. MAINTENANCE AND STORAGE
Before any intervention on product, ensure that switch is off and tool's plug is
disconnected from its power supply.
6.1- Maintenance
- Always wear gardening gloves when handling or working near the spool.
- Check your machine regularly before starting any work. Check the machine carefully and replace
worn or damaged parts for safety.
–
DURING OPERATION
, NOT
DO USE BY PRESSING THE SWITCH WITH JOLTS
.
.
Page 27 / 44