Anslut 019444 Mode D'emploi page 36

EN
MAINTENANCE
RECYCLING
Recycle end-of-life product in accordance with local
regulations. The light source should be removed from
the lamp and recycled separately. See description of
method below.
1. Undo the nuts and screws between the stand
and floodlight by hand.
2. Cut the top corner of the floodlight housing with
a hacksaw.
FIG. 5
3. Insert a flat-tip screwdriver in the gap between
the glass and the casing, and carefully pry both
parts apart. Stick another screwdriver between
the glass and the casing and carefully bend
apart. Continue along the edge round the lamp
until the glass comes loose.
FIG. 6
4. Lift off the glass to access the LED light source.
FIG. 7
5. Remove the light source.
36