Handheld Touch Radio Initialization - Ravelli Mia 90 Manuel D'utilisation Et D'entretien

Handheld touch radio initialization

After inserting the batteries or connecting the handheld unit to the electronic board of the cooker, the display will show a short
screen indicating the logo Ravelli, the screen with firmware version and the database and, finally, the screen for selecting the menu
language.
Select the desired language using the scroll keys and confirm your selection with the confirmation button.
In order to operate correctly, the handheld set should be interfaced with the electronic board installed inside the cooker. For this
reason, on display appears the following message:
If the handheld set is used for the first time, select YES using the selection keys and confirm with the dedicated key.
On the display of the handheld set appears the following:
Hold down for a few seconds the button of radio communication (RADIO ADJ) of the PCB to initialize the device.
The flashing yellow LED indicates that the circuit board is waiting to receive the signal from the handheld set.
By pressing the enter key on the handheld set, the components start communicating with each other. A check sign on the display,
accompanied by a sound signal, shows that the initialization of the handheld set has been completed successfully.
��
When you replace the batteries, you do not have to run the initialization procedure of the handheld set. In this case, when on
display appears the message "FIRST INSTALLATION ?", select NO and press the confirmation key.
Use and maintenance manual Mia 90
Rev.2 03/03/2021
Pag.30