General Faults; Table Of Faults; Troubleshooting - Kramp MS100 Manuel D'utilisation

Behavior in Basically the following applies:
the event of
1.
faults
2.
3.
4.
5.
7.2

Table of faults

7.2.1 General faults

Fault Possible cause
Electric motor without Electric power supply
function missing
Defective fuse
Damaged connecting cable
Electric motor turns off Thermal protection tripped /
after a short period of active
time.
Cup grinding wheel Unbalance, parts broken out
vibrates
7.3

Troubleshooting

7.3.1 Replacing the cup grinding wheel
.
rests safely against the end stop bolts.
1.
03/2015
Trigger the emergency function immediately in the event of faults that may cause personal injury or
property damage.
Find the cause of the fault.
If troubleshooting requires work in the hazard area, switch the machine off and secure it against
unauthorized restart.
Immediately notify the person in charge on site about the fault.
Depending on the type of the fault, correct the fault yourself or have it corrected by an authorized and
trained expert.
NOTICE!
The table of faults shown below specifies who is authorized to correct the fault.
IMPORTANT!
The cup grinding wheel must be used as specified by the manufacturer!
The cup grinding wheel may only be replaced by instructed operating
personnel!
The cup grinding wheel may only be used up to the end of the adjusting
range of the adjustable safety plate!
Also make sure that the curved knife is securely clamped into the horizontal clamping device and
Unscrew the cup grinding wheel on the bottom using a suitable tool and hold it with one hand.
Remedy
Attach the supply cable to the machine.
Replace the fuse in the control cabinet.
Replace the connecting cable.
Check the plug.
Is the electric motor connected properly as
specified in the circuit diagram?
Replace
Knife sharpener MS 100
Faults
To be corrected by
Operator
Trained electrician
Trained electrician
Trained electrician
Operator
29