Operating Sequence - Kramp MS100 Manuel D'utilisation

6.8 Operation
Personal protective
equipment
Information
Starting torque
Changing
knifes
Grinding
surface
6.8.1

6.8.1 Operating sequence

03/2015
Always wear the following protective equipment when operating the machine:
 Protective clothing
Safety shoes

 Safety goggles
Hearing protection

ATTENTION!
Get to know all elements of the knife sharpener and read the operating manual
carefully before placing the machine in operation!
ATTENTION!
Great starting torque of the electric motor. Therefore, hold on to the operating handle
when turning the machine on.
ATTENTION!
Knives must not be changed unless the cup grinding wheel is at a standstill.
ATTENTION!
Never touch the ground surface when the grinding process is complete as it is very
sharp and hot! GREAT RISK OF INJURY!
Follow this sequence when sharpening different knives:
. Also make sure that the curved knife is securely clamped into the horizontal clamping
device and rests safely against the end stop bolts.
1. Position and securely clamp the curved knife. See page 20, item 6.4 "Positioning the curved
knives."
. Also make sure that the curved knife is securely clamped into the horizontal clamping
device and rests safely against the end stop bolts.
2. Use the green switch (I) on the emergency stop button to turn the motor on while holding on
to the operating handle.
3. Grind the curved knife using regular right-left movements!
ATTENTION!
Do not apply too much grinding pressure! Using too much grinding
pressure will decrease the grade of the knife (blue coloration of the
grinding surface).
Watch out for flying sparks!
4. Repeat the grinding process until the knife is fully sharpened!
5. Switch the electric motor off, wait until the cup grinding wheel has come to a standstill, remove
the curved knife and clamp in the next knife to be sharpened following the instructions on page
20, item 6.4 "Positioning curved knifes".
Knife sharpener MS 100
Operation
23