Kramp MS100 Manuel D'utilisation page 66

Knife sharpener MS 100
Operation
6.11.3 Assembly
2
3
6.11.4 Operation
2
open
1
26
1.
1 1
2.
4
3.
4.
4
5
1.
3
2.
3.
closed
4.
Screw on the holder (1).
Screw on the holder (2) and the metering unit (3).
Connect the hose (4) with the metering unit. Proceed by routing the hose
behind the electric motor to the right before fixing the hose in place at the
electrical cable using cable ties.
Guide the hose (4) through the cover of the water can and shorten it as
necessary in order to ensure the aspiration of the greatest possible
amount of water.
NOTICE!
Tighten the screw coupling inside the water can cover,
making sure that you can still easily rotate the hose. This
will make it easier for you to remove the water can when
you need to fill it.
Fill the water can with clear water.
CAUTION!
Do not mix in any additives as they are hazardous to
the environment.
Close the gate valve (3).
Connect the compressed air hose (1).
CAUTION!
Maximum connection pressure 8 bar!
Position the nozzle of the flexible hose (4) in such a way that it points to
the blade closest to the guard.
03/2015