Positioning Knives For Krone Vp 1500 And Vp 1800 Round Bale Presses - Kramp MS100 Manuel D'utilisation

4

6.12 Positioning knives for Krone VP 1500 and VP 1800 round bale presses

Shown below are special setting specifications for knives used in Krone VP 1500 and VP 1800 round bale
presses!
6.12.1 Setting the adjusting plate/knife position on the adjusting plate
270 mm
The specified dimension is merely intended as a guide value!
6.12.2 Adjusting the grinding unit
6.12.2.1 Retaining plate – adjusting distance, grinding angle
The specified dimensions are merely intended as guide values!
275mm
03/2015
5. There are different ways to adjust the intensity of the cooling
process during sharpening:
6.
To shut the unit off, close the gate valve all the way.
IMPORTANT!
The specifications below are guide values as they may vary slightly depending on
the wear on the knives!
Correct position of the knife!
IMPORTANT!
You must turn the rotary unit of the grinding unit by 180°! See page 21, item 6.5
"Adjusting the grinding unit"
-
Water volume:
You can adjust the water volume using the adjustment
screw (2).
-
Atomizing:
The pressure can be adjusted in an infinitely variable
manner using the gate valve (3). The wider you open the
gate valve, the higher the pressure and the degree of
atomization.
NOTICE!
The cooling unit must be adjusted so that the
amount of water which is sprayed, evaporate
completely!
40mm
Knife sharpener MS 100
Operation
27