Operation; Unpacking The Appliance; Attaching The Accessories - Kärcher SC 1702 Mode D'emploi

2. Safety Instructions
electrical wiring and switches. The steam
could enter into the electrical components
and, on condensing, cause an electrical
defect.
Never touch the steam jet with your hand, or
direct it at persons or animals (scalding
hazard).
Materials containing asbestos and other
items known to contain hazardous
substances must not be steam-cleaned.
Operating the Unit
The operator may use the unit only as
described in the Operating Instructions. He is
obligated to observe local conditions and,
while working with the unit, take into account
the presence of third persons, and especially
children.
This device is not intended for use by persons
(including children) with reduced physical,
sensory or mental abilities or lacking
experience and/or knowledge, unless they
are supervised by a person responsible for
their safety or are instructed by these
persons on the use of the device. Children
should be supervised, to ensure that they do
not play with the device.
The unit must never be without supervision
while it is operating.
Maintenance
Prior to performing
maintenance procedures, and before
replacing parts, the unit must be switched
OFF, and the power plug must be
disconnected.
Repair and service procedures may only be
performed by authorised customer service
depots or by experts who are thoroughly
familiar with all applicable safety regulations.
Storage
C a u t i o n : Never operate or store the C a u t i o n : C a u t i o n :
C a u t i o n : C a u t i o n :
appliance in a horizontal position!
Protect the unit from rain. Do not store out-
side.
18 – English

3. Operation

Unpacking the Appliance

When you unpack the appliance, check that
everything is complete. If there are any missing
parts or you detect any transport damage,
please inform your dealer immediately.
Do not place the packaging into the
ordinary refuse for disposal. The
packaging materials can be recycled.
Please dispose of it at an appropriate
collection point.

Attaching the Accessories

• Firmly insert the modular accessory plug (C7)
• Connect the desired accessory part (D1, E1,
cleaning and
• If required, use the extension tubes (G1).
into the appliance connector (A1). Both pins of
the modular accessory plug must lock into the
cover of the appliance connector (see Figure 1).
Figure 1: Inserting the modular accessory plug
F1) with the steam gun (C1).
Put the tubular end of the accessory part on the
steam gun (C1). Then, push the accessory part onto
the steam gun until the unlocking button (C3) of the
steam gun locks into place (see Figure 2).
Figure 2: Attaching accessory to the steam gun
Attach one or both extension pieces (G1) to
the steam gun (C1) (see Figure 3). Then, push
the desired accessory part (D1, E1, F1, H1)
onto the free end of the extension tube.
Figure 3: Attaching the extension pieces
SC 1702