Connecting To The Internet - Kimex 160-4065T Manuel D'utilisation

• Connect the USB storage device to one of the USB
inputs on the Display.
• Launch the File Manager app from the All Apps
menu. Select your connected USB storage device
and press OK to browse the content. Highlight the
file with the extension ".apk" and press OK. Your
permission will be asked. Select Install and press
OK again to proceed.

Connecting to the Internet

To configure wired and wireless settings you should
access the Settings > Network & Internet menu.
In order to access the Settings menu, tap on the
Settings button (
Advanced button on the Settings Board. You can also
access the Settings menu from the Display options
menu when the Display is switched to a source other
than Home. Press the Menu button on the remote to
view the Display options menu.
To Connect to a Wired Network
There is an Ethernet socket on the rear side of your
Display. Connect your Display to your modem/router
via this Ethernet socket using an Ethernet cable. Refer
to the General View section on the first pages of this
manual to see the location of the socket.
The status of the Internet connection under the
Ethernet caption in the Network & Internet menu will
read 'Connected'. The MAC and IP addresses will also
be displayed under this caption.
3
Broadband ISP connection
1
Ethernet (LAN) cable
2
Ethernet (LAN) input (on the rear side of the
3
Display)
To Connect to a Wireless Network
A wireless LAN modem/router is required to connect
the Display to a wireless network.
Highlight the Wi-Fi option in the Network & Internet
menu and press OK to turn on the WLAN. Available
networks will be listed. Select one and press OK to
connect. You may be asked to enter a password to
connect to the selected network, in case the network
) on the Home Screen or the
1
2
is password protected. Additionally you can connect
to your router/modem via WPS or add new networks
by using the related options.
You can see the status of the connection under the
name of your network. It will read 'Connected' if the
connection is successful. Highlight your network under
the Available networks caption in the Network &
Internet menu and press OK to see the detailed
information on the connection such as MAC and IP
addresses. This way you can also access advanced
settings for the wireless connection such as proxy
and IP settings. You can also use the Forget network
option here to delete the connected wireless network
profile, so the Display will not connect to that network
automatically if it is available when the WLAN option
is turned on.
Broadband ISP connection
1
A network with hidden SSID (wireless network name)
can not be detected by other devices. If you want to
connect to a network with hidden SSID, highlight the
Add new network option under the Other options
caption and press OK. Add the network by entering
its name manually using the related option. To make
your modem's SSID visible, you should change your
SSID settings via the modem's software.
• A Wireless-N router (IEEE 802.11a/b/g/n/ac) with
simultaneous 2.4 and 5 GHz bands is designed
to increase bandwidth. These are optimised for
smoother and faster HD video streaming, file
transfers and wireless gaming.
• The frequency and channel differ depending on
the area.
• The transmission speed differs depending on the
distance and number of obstructions between the
transmission products, the configuration of these
products, the radio wave conditions, the line traffic
and the products that you use. The transmission may
also be cut off or may get disconnected depending
on the radio wave conditions, DECT phones or any
other WLAN 11b appliances. The standard values of
the transmission speed are the theoretical maximum
English - 22 -
1