General Use; Input Selection; Initial Setup; Home Screen - Kimex 160-4065T Manuel D'utilisation

General Use

The initial setup, the Settings and the Display options
menus are not fully compatible with the touch screen.
So it will be more convenient to use the remote control
when navigating through these menus and performing
initial setup process.
To interact with the user interface when on the Home
Screen or when working in an application, tap, tap
and hold or tap and drag with the included pen or your
finger. The Display also supports multitouch gestures
and more, so you can use two fingers to resize or
rotate objects, zoom in and out, and two or more
users can simultaneously write or draw while using
the applications or annotation tool.
Operation with the Remote Control
Press the Home button to display or return to the Home
Screen. You can only navigate through the elements
situated in the centre of the Home Screen using the
remote control buttons. Press the Right directional
button first to start navigating on the Home Screen with
the remote. Press the Menu button on your remote
control to display the Display options menu when
the Display is switched to a source other than Home.
Use the directional buttons to move the focus, proceed,
adjust some settings and press OK to make selections
in order to make changes, set your preferences, enter
a sub-menu, launch an application, etc. Press Back to
return to the previous menu screen or step.

Input Selection

Once you have connected external systems to your
Display, you can switch to different input sources.
Press the Source button on your remote control. Use
the directional buttons to highlight a source option and
press the OK button to switch to that source. Or expand
the General Tools Bar on the Home Screen, then tap
on the Source button. Available source options will be
displayed. Tap on any input source option to switch to it.
Adjusting the Volume and Brightness
You can adjust the volume by using the Volume
+/- buttons on the remote or on the front side of the
Display and the brightness by using the Brightness
+/- buttons on the remote.
You can also adjust the volume and brightness using
the dedicated sliders on the Settings Board. Tap on the
Settings button on the General Tools Bar to display
the Settings Board.

Initial Setup

When turned on for the first time, initial setup should be
performed. Follow the on-screen instructions to setup
your Display. The installation wizard will guide you
through the setup process. Use the directional buttons
and the OK button on the remote to select, set, confirm
and proceed. You can use the Back button to go back
to the previous steps and change your selections.
1. Welcome Message and Language Selection
"Welcome" message will be displayed along with
the language selection options listed on the screen.
Select the desired language from the list and press
OK to continue.
2. Country
In the next step select your country from the list and
press OK to continue.
3. Display Operation Mode
The Display Operation Mode selection screen will be
displayed next. For normal operation set to Reactive.
Set to Eco for an energy-efficient operation. In this
mode your Display's settings will be configured to
reduce the energy consumption.
When the initial setup is completed a message will be
displayed. Press OK to finish the setup. Home Screen
will be displayed.
You can repeat the initial setup process and reset
the Display's settings to the factory defaults anytime
using the Reset option in the Settings > Device
Preferences menu. You can access the Settings
menu from the Home screen or from the Display
options menu if the input source is not set to Home.

Home Screen

After the initial setup, the Display will be opened with
the Home Screen. To be able to use the widgets, tools,
applications and access the settings and user-specific
content, login will be required. Refer to the Login and
Account Management System (AMS) sections for
more information. After you logged in, Home Screen
of your user account will be displayed.
Following widgets will be available on the home screen:
In the centre
• Favourite applications and Add (Plus sign)
• Settings (
• Login (
user logged in)
English - 12 -
Favorite Favorite Favorite
- only if user logged in)
- if user not logged in) / Log out (
+
- if