Embedded Infrared Overlay Touch Screen - Kimex 160-4065T Manuel D'utilisation

1
1.
Standby Button
2. Power LED
3. Power Switch (*)
4.
Standby Button
(*) The location of the power switch may differ depending on the model
Power LED Status
Not lit
Lit
Flashing (slow)
Flashing (fast)

Embedded Infrared Overlay Touch Screen

Infrared Overlay Touch Screen adds touch screen feature to your Display. The Touch Screen is connected
internally to the Display. If you switch the Display's source to the embedded OPS (if available), touch screen
feature can be used with the OPS. It can also be used with external source devices. In this case the external
source device should be connected to the Display via a USB (type-B) to USB (type-A) cable. Connect the USB
Type-B end of the USB to USB cable to the USB Type-B port of the Display and the USB Type-A end to the
external source device as shown in the example connection below. Touch screen will become functional after
a short period of time. The Touch Screen can also be used with the Internet Browser (if available) which can
be launched from the Displays menu.
The Touch Screen is HID compliant. Windows, Linux, Mac and Android operating systems support HIDs. But
in some cases a driver/patch may be required in order to use the touch screen with an external source device.
In this case, the required driver/patch should be installed onto the external source device. Otherwise the Touch
Screen may not work properly. Refer to the user manual of the source device for further information.
If the operating system of the source device does not recognise the touch screen after the connection has
been established (a message may appear on the screen of the source device stating that the USB device is
not recognised), disable and then re-enable the touch screen by pressing the dedicated button on the front
side of the Display. Refer to Control Buttons on the Display section if you need further information on the
buttons on the Display and their functions.
Touch screen controls the currently displayed image on the screen of the Display. If an embedded OPS is
being used the touch screen controls the embedded OPS. If an external source device is connected via HDMI,
VGA, DP or USB Type-C and the source is selected accordingly, then the connected device will be controlled.
Vol
2
Status of the Display
Power on (operating mode, quick standby mode)
Power off (standby mode)
Turning on or off
Software update
English - 9 -
4
3