Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Control Buttons on the Display
1.
Settings menu
2.
Source / Select (when in the Display Options menu)
3.
Enable / Disable touch screen
4.
Volume - / Move the focus left (when in the Display Options menu)
5.
Volume + / Move the focus right (when in the Display Options menu)
6.
Quick Standby / Standby / On
Turning the Display On/Off
Connect power
IMPORTANT: The Display is designed to operate on 110-240V AC, 50/60 Hz socket.
After unpacking, allow the Display to reach the ambient room temperature before you connect it to the mains.
Plug the power cord into the mains socket outlet.
Turn on the power switch on the Display - position "1" (
the power LED will light up.
To switch on the Display
If the Display is in standby mode or quick standby mode, the power LED lights up. To switch on the Display either
press the Standby button on the remote control or on the front side of the Display. The Display will then switch on.
To switch the Display into standby mode
In order to switch the Display into standby mode press and hold the Standby button on the remote control
or on the Display. Power off dialogue will appear on the screen. Highlight OK and press the OK button. The
Display will switch into standby mode.
To switch the Display into quick standby mode
In order to switch the Display into quick standby mode either press the Standby button on the remote control
or on the Display. Press the button again to go back to operating mode.
Note: If the Power Mode option in the Power menu (Settings > Device Preferences / Display Options) is set to Eco, the
Display will switch into standby mode when the Standby button is pressed.
To switch off the Display
Turn off the power switch on the Display - position "2" (
Display completely, unplug the power cord from the mains socket.
Vol
). The Display will switch into standby mode and
). The Display will switch off. To power down the
English - 8 -
1 1
2
3
4
5
6
Publicité
Chapitres
Table des Matières
