Connecting And Linking; Remote Control - Kimex 164-5525 Manuel D'utilisation

CONNECTING AND LINKING

This is a Class A device, which means that it may cause radio interference effects in its environment like any other
device with a large LED panel and Wi-Fi transmission system. It is potentially sensitive to interference from
surrounding devices. If this is the case, please check for other equipment in the vicinity.
Do not place the monitor in direct sunlight or near a heat source as this may damage it.

REMOTE CONTROL

Battery installation
•
Remove the battery cover on the back of the remote control
and insert two AAA (1.5V) batteries. Make sure that the polarity
matches the + and - marks on the battery compartment of the
remote control.
• Do not use different types of batteries. Never mix new and old
batteries. Always replace batteries in pairs.
• Do not burn, charge or disassemble batteries.
Never dispose of used batteries with household waste but in the
recycling bins provided for this purpose, e.g. in your
supermarkets or in accordance with local environmental
regulations.
Page 19 de 20