EBRO ARMATUREN EP 501 Démarrage Rapide page 17

Type EP 501
Attachmentandassembly
Anti-twist safeguard:
Note the flat side of the shaft!
One of the setscrews must be situated on the flat side of the shaft
as an anti-twist safeguard (see „Fig. 6").
Rotation range of the position sensor:
The maximum rotation range of the position sensor is 180°.
The shaft of the Type EP 501 / EP 501 C may be moved within this
range only.
180°
Maximum
swing range
Flattened shaft
The swing movement of the flattened
shaft must be within the position
sensor turning range of 180°.
Fig. 6: Rotation range / anti-twist safeguard
→
Assemble the multi-part assembly bridge* suitable for the
actuator.
→
Attach the assembly bridge to the Type EP 501/EP 501 C using
③
4 cheese-head screws
④
③
* The assembly bridge consists of 4 parts
which can be adjusted to the actuator by
varying the arrangement.
Fig. 7: Attach assembly bridge (schematic representation)
english
④
and circlips (see „Fig. 7").
17