Quick Start - Samson CONCERT 288 Manuel Du Propriétaire

Quick Start

In order for your wireless system to work correctly, both the receiver and transmitter
must be set to the same channel.
Follow this basic procedure for setting up and using your Concert 288 wireless
system:
Physically place the CR288 receiver where it will be used, and extend the antennas
vertically. The general rule of thumb is to maintain "line of sight" between the
receiver and transmitter so that the person using or wearing the transmitter can see
the receiver.
With the CR288 powered off, connect the included power adapter. Turn the CR288
on momentarily to confirm that the unit is receiving power. You'll see the LED display
light up. Then turn the CR288 power off.
With your amplifier or mixer off and volume control all the way down, connect the
CR288 receiver mix output jack to the line level input of a mixer or amplifier. Turn
the Level knob on the CR288 completely counterclockwise, then turn its power on.
14