Samson CONCERT 288 Manuel Du Propriétaire page 17

Quick Start
When the transmission is complete, the CR288 will
receive RF signal and the tone key from the transmitter.
The CH A READY indicator will light on the front panel
of the CR288 receiver. Repeat these steps for the CH
B transmitter and receiver. CH A and CH B available
frequency channels do not overlap, so you can set the
two receivers to the same channel number or letter.
Turn on your connected amplifier or mixer, but keep
the volume all the way down. Set the Volume knob
on the CR288 fully clockwise (to its "10" setting).
This is unity gain.
Speak or sing into the microphone. Slowly raise the volume of your amplifier or mixer
until the desired level is reached.
If you find the system has noticeable dropouts, reduced overall working range, or
unexpected noise bursts, change the operating channel of the system using the steps
above.
When using multiple systems in the same frequency band, each system must be set to a
different operating channel. (See "Concert 288 Channel Plans" on page 18).
17
Concert 288 Dual Channel Wireless System