Radio Overview; Radio Controls - Motorola CP160 Guide Simplifie

RADIO OVERVIEW

Radio Controls

The numbers below refer to the illustrations on the
inside front and rear covers.
1. Push-to-talk (PTT)
Press and hold down this button to talk;
release it to listen.
2. On-Off / Volume Knob
Used to turn the radio on or off, and to adjust the
radio's volume.
3. Channel Selector Knob
Used to switch the radio to different channels.
4. LED Indicators
Indicate radio status:
Green: Solid during power up routine; off after
successful power up; flashing when scanning.
Red: Solid - transmitting; Flashing when trans-
mitting - low battery:
Flashing - channel is busy receiving.
Yellow: Solid when radio is in monitor mode,or
is sending a selective call or call alert;
Flashing - receiving a selective call or call alert.
5. Microphone/Speaker
Hold the microphone 2.5 to 5 cm (1-2 inches)
from your mouth, and speak clearly into it.
English 2
CP140 Radios
6. Side Button 1
7. Side Button 2
8. Accessory Connector
Connects remote microphones, remote ear-
phones and other accessories. Replace dust
cap when not in use.
9. Belt Clip
CP160/CP180 Radios
6. LCD Display
An 8 character single line display with up to 9
radio status icons.
J J J J
7. Front Button P2
8. Menu Scroll Buttons L M
K K K K
9. Front Button P1
10. Side Button 2
11. Side Button 1
12. Accessory Connector
Connects remote microphones, remote
earphones and other accessories. Replace dust
cap when not in use.
13. Belt Clip
CP180 Radio Only
14. DTMF Keypad