Scope Of Delivery; Residual Risks; Intended Use; Safety Information - Scheppach DECO-XLS Traduction Des Instructions D'origine

36. Fine-wire fuse
37. Adjustment screw with locknut

3. Scope of delivery

• Scroll saw
• Saw blade guard (5) with depressor (24)
• Blow-off device (1)
• Saw blade (22) for wood and plastics (4x)
• 1 bolt bag: 5 hexagonal bolts M8 x 50,
4 hexagonal nuts M8, 8 washers
• Allen key, 3 mm (23)
• Operating manual

4. Intended use

The fretsaw was designed to cut square-edged timber
or other workpieces such as Plexiglas, glass fiber rein-
forced plastic, foam, rubber, leather, and cork. Do not
use this saw to cut round materials. Round materials
can easily become jammed.
Risk of injury! Parts can be catapulted!
The equipment may only be used for the tasks it is de-
signed to handle. Any other use is deemed to be a case
of misuse. The user/operator and not the manufactur-
er will be liable for any damage or injuries of any kind
caused as a result of this.
Please note that our equipment has not been designed
for use in commercial, trade or industrial applications.
Our warranty will be voided if the equipment is used in
commercial, trade or industrial businesses or for equiv-
alent purposes.
• The equipment is to be operated only with suitable
saw blades.
• To use the equipment properly you must also ob-
serve the safety information, the assembly instruc-
tions and the operating instructions to be found in
this manual.
• All persons who use and service the equipment
have to be acquainted with these operating instruc-
tions and must be informed about the equipment's
potential hazards.
• It is also imperative to observe the accident preven-
tion regulations in force in your area.
• The same applies for the general rules of health and
safety at work.
26 | GB
• The manufacturer will not be liable for any changes
made to the equipment nor for any damage resulting
from such changes.

Residual risks

Even if you use this electric power tool in accord-
ance to instructions, certain residual risks cannot
be eliminated. The following hazards may arise in
connection with the equipment's construction and
layout:
• Lung damage if no suitable protective dust mask is
applied
• Damage to hearing if no suitable ear protection is
applied
• Contact with the blade in the uncovered cutting zone
• Injuries (cuts) when changing the blade
• Crushed fingers
• Kickback
• Tilting of the workpiece due to inadequate support
• Touching the blade
• Catapulting of pieces of timber and workpieces

5. Safety information

5.1 General safety information on electric power
tools
CAUTION
The following basic safety measures must be observed
when using electric tools for protection against electric
shock, and the risk of injury and fire.
Read all these notices before using the electric tool and
store the safety instructions well for later reference.
Maintenance and service
1. Regular cleaning, maintenance, and lubrication.
Pull out the mains plug before making any settings,
service or repair work.
2. Only have your device repaired by qualified spe-
cialists and only with original spare parts. This en-
sures that safety of the device is maintained.
Safe work
1. Keep your work area tidy
- Disorder in the work area can lead to acci-
dents.
www.scheppach.com