Operation; Preparation; Self Test At Power On; Waiting Period - Leitronic AG bebetelEXTRA Manuel D'utilisation

6

Operation

6.1 Preparation

If you want to monitor a sleeping baby please place bébétel
your baby
Note:
To avoid false alarms close windows and diminish other noise sources.
Do not place your mobile on top of the bébételMOBILE
Monitor two rooms

6.2 Self test at power on

®
When bébétel
is switched to ON it checks battery state and telephone-line condition.
If one of these tests fails the user will be informed by beeps as follows:
3 beeps: Battery is low
6 beeps: Land line mode: Idle tone not detected
Mobile mode: Mobile phone not detected

6.3 Waiting period

During the waiting period the indicator LED is green.
6.3.1 after power on
®
bébétel
remains inactive for a waiting period of two minutes so you can leave your room without triggering a
call.
If you want to skip this period, press Key
response sensitivity.
6.3.2 after a successful call
®
bébétel
remains inactive for a waiting period of two minutes to avoid frequent calls.

6.4 Test call (=direct call)

In order to check that the telephone number has been entered correctly, you
should perform a test call:
1. Press any key
The colour of the indicator LED changes to orange during any connection
2. Wait until connection is established and speak
3. Terminate connection by pressing 0. or switch to off.
Note:
An older child can call you by pressing any key. You can then talk to one another.
After ten minutes the connection will automatically be disconnected. You can hang up by pressing key 0 or
stay connected by pressing 3 on your telephone.
6.4.1 Adjust hands-free volume
During voice connection you can increase volume by pressing key
be adjusted (spanning ten sound levels) and remains stored.
®
bébételMOBILE
: In mobile use only possible with mains supply and if the attached mobile phone
supports the speak with child -mode

6.5 Monitoring mode

After the waiting period bébétel
every four seconds and lights up when the noise level exceeds the level given by the sensitivity switch.
7.4.
7.7
9
1.3 or www.bebetel.com/mobiles).
(
®
switches to monitoring mode. In this mode, the indicator LED flashes green
®
about 1m to 2m from
®
to avoid interference.
10
1.3
to activate monitoring mode, for example to test the
.# or decrease by pressing key .*.. Level can
O FF O N
PRO G
2Min.
OFF ON
PROG
OFF ON
PROG
47