Auto Answer; Trouble Shooting - Leitronic AG bebetelEXTRA Manuel D'utilisation

Note:
If the number is entered correctly there will be one beep at the end of the input. Wrong re-entering will
provoke two beeps. Incorrect number will not be stored so the former value remains active.
If you key a wrong number set function switch to OFF and repeat steps 1 to 7.

9.3 Auto answer

If you want to change the number of rings prior to answer, you can proceed as follows:
1. Set function switch to PROG
2. Press .*.
.9 .7 .1 .3 .4 .7 <n>
3. Enter
4. Press .#.
5. Enter .9 .7 .1 .3 .4 .7 <n>
6. Press .#.
7. Set function switch to OFF
<n> Comment
®
2..9 bébétel
answers call after n rings
®
bébétel
10
does not answer any incoming call
Note:
If the number is entered correctly there will be one beep at the end of the input. Wrong re-entering will
provoke two beeps. Incorrect numbers will not be stored so the former value remains active.
If you key a wrong number set function switch to OFF and repeat steps 1 to 7.
Default value is 2 rings.

10 Trouble shooting

You can clear most faults checking the following list. If a problem cannot be resolved please check our
interactive error handling on our homepage www.bebetel.com or contact Info-
Problem
The indicator LED does not
shine when switched on
Three beeps when switched on
Six beeps when switched on
No connection with test call
dial tone not present
No connection with test call
dial tone present
No access using dialling-in
functionality call will be
disconnected after PIN-code
input together with two beeps
No access using dialling-in
functionality in mobile use:
Mode cannot be changed using
touch tone commands
(n see table below)
once again for confirmation
Cause and/or remedy
7.7
Replace battery
Battery is low replace it
®
bébétel
is not connected to an analogue telephone line
Pin compatibility error (telephone cord
Telephone network is down
Line is busy because a parallel telephone set is in use
plug in telephone cord
check telephone cord
make a call with another telephone set
Mobile phone is not detected, not connected or not compatible with
®
bébételMOBILE
(
Telephone number has been wrong
Called subscriber does not accept call
Wrong PIN-code has been entered
Used telephone set does not support touch tone or is in the wrong mode
Volume incorrect adjust connected mobile phone to medium volume
®
bébételMOBILE
: In mobile use only possible with mains supply
and if the attached mobile phone supports the speak with child -
1.3 or www.bebetel.com/mobiles).
mode (
Used telephone set does not support touch tone or is in the wrong mode
for instance pulse-dialling or an ISDN-telephone
Mobile use: Volume incorrect
medium volume
®
bébételMOBILE
: In mobile use only possible with mains supply
and if the attached mobile phone supports the speak with child -
1.3 or www.bebetel.com/mobiles).
mode (
+41 (0)56 648 40 40.
7.7
telephone line)
1.3 or www.bebetel.com/mobiles)
re-program PIN-code
adjust connected mobile phone to
53