Connection Fee Due To Telephone Call; Use With An Answering Machine; Monitoring Two Rooms; Touch Tone Commands - Leitronic AG bebetelEXTRA Manuel D'utilisation

7.2 Connection fee due to telephone call

®
bébétel
only starts a call if an alarm condition is detected. Please note that you will incur costs for calls to
your mobile or pager. These may vary according to certain factors such as time of day or day of the week and
should therefore be confirmed by your individual service provider. Make sure that rejected calls are not
diverted to an answering machine.

7.3 Use with an answering machine

The factory setting of the monitor means it will answer a call after two rings. The caller then has 15 seconds in
which to enter their PIN-code. If the PIN-code is wrong, or is not entered on time, bébétel
®
want to use bébétel
together with an answering machine you have to adapt the number of rings for both units
®
and answering machine). To program the number of rings for bébétel
(bébétel
machine please consult relevant manufacturer's instructions. If you adapt both units for the same number of
rings, you can dial in and enter PIN-Code within 15 seconds to monitor the room. A caller who does not enter
PIN-Code within 15 seconds will only hear the spoken message of your answering machine and will not know
that the monitor has automatically disconnected due to PIN-code time-out.

7.4 Monitoring two rooms

®
Because bébétel
is very sensitive on position HIGH it is possible to monitor two rooms next to each other.
You can place the alarm-unit between the two rooms, leaving the doors open! Please check sensitivity by
creating some noise activity. We recommend using the additional motion detector monitoring (COMBI
ensure that the child cannot leave the room unnoticed.
If the two rooms are not close enough you can always use two bébétel

7.5 Touch tone commands

If you want to use bébétel
call should be answered. Most of today's telephone sets send touch tone signals also known as DTMF or tone
dialling. Older telephone sets use pulse dialling. If you are not sure if your telephone set uses touch tone, you
may run the following check: Lift handset and dial any number
possession of a touch tone telephone set. If you hear pulses you might be able to program your telephone set for
touch tone or you can buy an acoustic coupler. If you do not have any touch tone device you cannot execute
touch tone commands
®
bébételMOBILE
supports the speak with child -mode

7.6 Signals (beeps)

®
Beeps from bébétel
loudspeaker
Number Message/Cause
1 Acknowledgement beep
2 Wrong re-entering of PIN-code, ringing cycle etc.
3 Battery is low
6 Dial-tone missing
Beeps in called telephone
Number Message/Cause
1 Acknowledgement beep
2 PIN-code has been entered incorrectly or activation by motion detector (no motion at the moment)
3 Activation by motion detector (motion still going on)
4
Connection time-out
®
bébételMOBILE
supports the speak with child -mode
50
®
to its full potential, you need a touch tone telephone set at the line, where telephone
6.7.
: In mobile use only possible with mains supply and if the attached mobile phone
(
6.7.1
: In mobile use only possible with mains supply and if the attached mobile phone
(
®
in parallel.
if you hear dialling tones you are in
1.3 or www.bebetel.com/mobiles).
1.3 or www.bebetel.com/mobiles).
®
hangs up. If you
®
9.3. For your answering
®
) to