Accessories - Kärcher B 80 W Bp Mode D'emploi

Insufficient vacuum Clean the seals between dirty water reservoir and cover and check for tightness, replace if required.
performance
Wastewater reservoir is full; shut off the appliance and empty the wastewater reservoir
Clean the lint trap.
Clean the squeegee blades on the squeegee tool, replace if required
Check suction hose for blockages; clean if required.
Check the suction hose for tightness; replace if required.
Check if the cover on the dirty water discharge hose is closed
Check the setting of the squeegee tool.
Suction turbine does Turn programme selection switch to "OFF". Afterwards, set it back to the desired programme (this is necessary
not run after emptying to reset the swimmer switch).
the dirt water reservoir
Insufficient cleaning re- Check the brushes for wear, replace if required.
sult
Vibrations during Cleaning head has play, open the excenter lever and press the cleaning head all the way against the push
cleaning handle, close the excenter lever.
You might need to use softer brushes.
Brushes do not turn Check if foreign matters block the brushes; remove foreign matter if required.
If over-current switch in the electronics system has been triggered, turn programme selection switch to "OFF".
Afterwards, set it back to the desired programme.
In case of faults that cannot be remedied using the table below please contact the customer service.
Description
Brush roller, red (medium, stan-
dard)
Brush roller, white (soft)
Brush roller, orange (high/ low)
Brush roller, green (hard)
Brush roller, black (very hard)
Pad roller shaft
Roller pad, yellow (soft)
Roller pad, red (medium)
Roller pad, green (hard)
Description
Disk brush, natural (white)
Disk brush, white
Disk brush, red (medium, standard)
Disk brush, black (hard)
Driver plate pad
14

Accessories

BR appliance B 80 (brush roller accessories)
Part no.: Part no.:
Working width Working width
25.6 in. (650 mm) 29.6 in. (750 mm)
6.906-935.0 6.906-936.0
6.906-981.0 6.906-985.0
6.906-982.0 6.906-986.0
6.906-983.0 6.906-987.0
6.906-984.0 6.906-988.0
4.762-433.0 4.762-434.0
6.369-454.0 6.369-454.0
6.369-456.0 6.369-456.0
6.369-455.0 6.369-455.0
BD appliances B 80 (disc roller accessories)
Part no.:
Working width
25.6 in. (650 mm)
4.905-012.0
4.905-011.0
4.905-010.0
4.905-013.0
4.762-446.0
Description
Also for regular cleaning of heavily dirtied
floors.
For polishing and cleaning sensitive floors.
For scrubbing structured floors (safety tiles,
etc.).
For thoroughly cleaning heavily dirtied floors
and for removing the coating (for e.g. of wax,
acrylate).
For intake of roller pads.
For polishing floors.
For cleaning slightly dirtied floors.
For cleaning normal to heavily dirtied floors.
Part no.: Description
Working width
29.6 in. (750 mm)
4.905-020.0 For polishing floors.
4.905-019.0 For polishing and cleaning sensitive floors.
4.905-018.0 For cleaning slightly dirtied or sensitive
floors.
4.905-021.0 For cleaning heavily dirtied floors.
4.762-447.0 For intake of pads.
12
-
US
1 2
1 2
1 2
1 2
1 2
1 2
20 96; 106
20 96; 106
20 96; 106
1 2
1 2
1 2
1 2
1 2