Installation And Commissioning; Recommended System Layout - Parker PNEUDRI MXLE Serie Mode D'emploi

3 Installation and Commissioning

Only competent personnel trained, qualified, and approved by Parker domnick hunter should perform installation,
commissioning, service and repair procedures.

3.1 Recommended System Layout

The dryer should be installed, downstream of a 'wet' air receiver, with the pre-filtration supplied and optional condensate management equipment
to meet both the specification and local environmental requirements. This includes the following components:
Water separators (Optional) - Water separators are used to protect coalescing filters against bulk liquid contamination, where excessive cooling
takes place in air receivers and distribution piping. Using mechanical separation techniques, Parker domnick hunter water separators will remove
in excess of 92% bulk liquid contamination at all flow conditions.
General purpose and high efficiency coalescing filters (Supplied) - Coalescing filters are probably the single most important items of
purification equipment in a compressed air system. They are designed to not only remove aerosols (droplets) of oil and water using mechanical
filtration techniques, but also to remove solid particulate to very low levels (as small as 0.01micron in size). Installed in pairs, the first filter is a
'general purpose filter' which protects the second 'high efficiency filter' from bulk contamination. The dual filter installation from Parker domnick
hunter ensures a continuous supply of high quality compressed air with the additional benefits of low operational costs and minimal maintenance.
Note. Failure to install and maintain the pre and after filtration, supplied with the dryer and configured as illustrated below, will
invalidate the dryers warranty.
Ref Description
1 MXLE Dryer
2 Vacuum Pump
3 Water Separator
4 General Purpose Filter
12
<2m (78.7 ins)
Ref Description
5 High Efficiency Filter
6 General Purpose Filter
7 Isolation Valve
8 Electronic Condensate Drain