Operation - IKEA SUPERKALL Mode D'emploi

ENGLISH

Operation

Control panel
1
Temperature indicator
2
Function button
Switching on
Warning! Refer to "Electrical connection"
section of the Safety chapter.
Connect the mains plug to the power socket.
The display on the control panel turns on.
To change temperature, refer to the section for
temperature regulation.
set the appliance at a colder temperature and
run it without loading any food until it auto
stops at the set temperature. Usually it takes
2 or 3 hours, then set a desired temperature and
put food in the appliance.
Do not use sharp object to control the touch
panel.
•
2
the Function button on the control
panel for 10 seconds. After 30 seconds,
• To switch the appliance on again, press the
2
Function button.
2
To disconnect the appliance from the power
supply, disconnect the mains plug from the
power socket.
Locking/unlocking
• If the door is closed and no button
operation occurs for 30 seconds, the control
panel will be locked. Button operation is
invalid.
• To unlock the control panel, press and hold
2
the Function button on the control panel
for 3 seconds. Button operation is available.
Temperature regulation for refrigerator
compartment
2
• Press the Function button on the control
panel to toggle a preset temperature.
The four LEDs indicated from
corresponds to the following temperatures:
36°F (2°C), 39°F (4°C), 43°F (6°C) and 46°F
(8°C). The appliance will run at the newly set
temperature 30 seconds later.
Adjust the temperature setting by keeping in
mind that the temperature inside the appliance
depends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance
Important! If the ambient temperature is
high or the appliance is fully loaded, and the
appliance is set to the lowest temperatures, it
may run continuously causing frost to form on
the rear wall. In this case a higher temperature
must be set to allow automatic defrosting and
therefore reduced energy consumption.
12
to