IKEA SUPERKALL Mode D'emploi page 17

Masquer les pouces Voir aussi pour SUPERKALL:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
Problem
The appliance is noisy.
The lamp does not work.
The compressor operates
continually.
The temperature in the appliance
is too low/too high.
There is too much condensed
water on the rear wall of the
refrigerator.
Water flows inside the
refrigerator.
Water flows on the floor.
Possible Cause
The appliance is not placed stably.
The lamp is defective.
Temperature is set incorrectly.
Many food products were inserted at the
same time.
The room temperature is too high.
Food products placed in the appliance
were too warm.
The door is not closed correctly.
The temperature is not set correctly.
The door is not closed correctly.
The food products temperature is too
high.
Many food products are inserted at the
same time.
The thickness of the frost is greater than
0.16"-0.20".
The door has been opened often.
There is no cold air circulation in the
appliance.
Door was opened too frequently.
Door was not closed completely.
Stored food was not wrapped.
The drain hole at the back of the
appliance is clogged.
Food products prevent water from
flowing into the water collector.
The door is not closed well.
The appliance tilts forward.
The drip pan cracks.
The defrost water drain is clogged.
Solution
Check if the appliance stands
stable.
Refer to "Replacing the lamp".
Refer to "Operation" chapter.
Wait some hours and then check
the temperature again.
Refer to climate class chart on the
rating plate.
Allow food products to cool to
room temperature before storing.
Refer to "Closing the door".
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products temperature
decrease to room temperature
before storage.
Insert less food products at the
same time.
Defrost the appliance.
Open the door only if necessary.
Make sure that there is cold air
circulation in the appliance.
Open the door only when
necessary.
Make sure the door is closed
completely.
Wrap food in suitable packaging
before storing it in the appliance.
Clean the drain hole with a piece
of wire.
Make sure that food products do
not touch the rear plate.
Refer to "Closing the door", or
refer to the troubleshooting item
below ("The door does not close
completely").
Tilt the appliance slightly backward
(a quarter-inch lower in the back).
Refer to the separate Assembly
Instructions for appliance level
adjustment.
Contact Authorised Service Centre
listed at the end of this manual.
Clean the drain hole with a piece
of wire.
17

Publicité

Table des Matières
loading

Table des Matières