IKEA SUPERKALL Mode D'emploi page 8

ENGLISH
• Follow the installation instruction supplied
with the appliance.
• Always take care when moving the
appliance as it is heavy. Always use safety
gloves and enclosed footwear.
• Make sure the air can circulate around the
appliance.
• Do not tilt the refrigerator for more than 45°
form upright during moving it.
• At first installation or after reversing the
door wait at least 4 hours before connecting
the appliance to the power supply. This is to
allow the oil to flow back in the compressor.
• Before carrying out any operations on the
appliance (e.g. reversing the door), remove
the plug from the power socket.
• Do not install the appliance close to
radiators or cookers, oven or hobs.
• The rear of the appliance must stand
against the wall.
• Do not install the appliance where there is
direct sunlight.
• Do not install this appliance in areas that
are too humid or too colds, such as the
construction appendices, garages or wine
cellars.
• When you move the appliance, lift it by the
front edge to avoid scratching the floor.
Electrical connection
Warning! Risk of fire and electrical shock.
Warning! When positioning the appliance,
ensure the power cord is not trapped or
damaged.
Warning! Do not use multi-plug adapters
and extension cords.
Warning! Do not, under any
circumstances, cut, remove, or bypass the
grounding prong.
3-prong plug
Grounding pin
3-prong receptacle
Ground receptacle box
• The appliance must be earthed. The
appliance must be plugged into its own
dedicated 115 Volt, 60 Hz,15 Amp, AC only
electrical outlet. The power cord of the
appliance is equipped with a 3-prong
grounding plug for your protection
against electrical shock hazards. It must be
plugged directly into a properly grounded
3-prong receptacle. The receptacle must be
installed in accordance with local codes and
ordinances. Consult a qualified electrician.
Avoid connecting refrigerator to a Ground
Fault Interrupter (GFI) circuit.
• If there is a 2-prong standard wall socket,
it is the responsibility of the customer to
have this socket replaced with a correctly
grounded 3-prong wall socket.
• Never unplug the appliance by pulling on
the power cord. Always grip the plug firmly,
and pull straight out from the receptacle to
prevent damaging the power cord.
• Performance may be affected if the
voltage varies by 10% or more. Operating
the appliance with insufficient power can
damage the compressor. Such damage is
not covered under your warranty.
• Do not plug the appliance into an electrical
outlet controlled by a wall switch or pull
cord to prevent the appliance from being
turned off accidentally.
• Make sure that the parameters on the rating
plate are compatible with the electrical
ratings of the mains power supply.
• Always use a correctly installed shockproof
socket.
• Make sure not to cause damage to the
electrical components (e.g. mains plug, power
cord, compressor). Contact the Authorised
Service Centre or an electrician to change the
electrical components.
• The power cord must stay below the level of
the mains plug.
• Connect the mains plug to the mains socket
only at the end of the installation. Make sure
that there is access to the mains plug after
the installation.
Use
Warning! Risk of injury, burns, electrical
shock or fire.
8