Troubleshooting - IKEA SUPERKALL Mode D'emploi

Masquer les pouces Voir aussi pour SUPERKALL:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
Caution! Do not damage the cooling
system.
Caution! When moving the cabinet, lift it
by the front edge to avoid scratching the
floor.
The equipment has to be cleaned regularly:
1.
Clean the inside and accessories with
lukewarm water and some neutral soap.
2.
Regularly check the door seals and wipe
clean to ensure they are clean and free from
debris.
3. Rinse and dry thoroughly.
4. If accessible, clean the condenser and the
compressor at the back of the appliance
with a brush. This operation will improve
the performance of the appliance and save
electricity consumption.
Periods of non-operation
When the appliance is not in use for long
periods, take the following precautions:
1.
Disconnect the appliance from electricity
supply.
2.
Remove all food.
3. Defrost (if necessary) and clean the
appliance and all accessories.
4. Clean the appliance and all accessories.
5. Leave the door/doors open to prevent
unpleasant smells.
Caution! If you want to keep the appliance
switched on, ask somebody to check it
once in a while to prevent the food inside
from spoiling in case of a power failure.

Troubleshooting

Warning! Refer to Safety chapters.
What to do if...
Problem
The appliance does not operate.
Defrosting refrigerator compartment
Frost is automatically eliminated from the
evaporator of the refrigerator compartment
every time the motor compressor stops,
during normal use. The defrost water drains
out through a trough into a special container
at the back of the appliance, over the motor
compressor, where it evaporates.
It is important to periodically clean the defrost
water drain hole at the back of the refrigerator
compartment to prevent the water overflowing
and dripping onto the food inside.
For this purpose use the tube cleaner provided
in the accessory bag.
Defrosting freezer compartment
The freezer compartment has automatic
defrosting function.
Due to seasonal changes, a thick layer of frost
may form. To defrost manually, observe the
followings.
Possible Cause
The appliance is switched off.
The mains plug is not connected to the
mains socket correctly
There is no voltage in the mains socket.
Disconnect the appliance from the power
supply, and leave open the freezer door.
Remove all foods, ice cube tray and shelf or
transfer to refrigerator compartment.
Clean and wipe out the melted frost with a
cloth.
After defrosting, connect the appliance to
the power supply.
Caution! To avoid damaging the freezer
compartment wall, do not use any sharp
objects to remove the frost or separate the
frozen food.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly. Refer to
"Electrical connection" section of
the safety chapter.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
16
Solution

Publicité

Table des Matières
loading

Table des Matières