Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
Remove all foods, ice cube tray and shelf or
transfer to refrigerator compartment.
Clean and wipe out the melted frost with a
cloth.
After defrosting, connect the appliance to
the power supply.

Troubleshooting

Warning! Refer to Safety chapters.
What to do if...
Problem
The appliance does not operate.
The appliance is noisy.
Acoustic alarm is on.
The lamp does not work.
The compressor operates
continually.
Possible Cause
The appliance is switched off.
The mains plug is not connected to the
mains socket correctly
There is no voltage in the mains socket.
The appliance is not placed stably.
The door is left open.
The lamp is defective.
Temperature is set incorrectly.
Many food products were inserted at the
same time.
The room temperature is too high.
Food products placed in the appliance
were too warm.
The door is not closed correctly.
Caution! To avoid damaging the freezer
compartment wall, do not use any sharp
objects to remove the frost or separate the
frozen food
Switch on the appliance.
Connect the mains plug to the
mains socket correctly. Refer to
"Electrical connection" section of
the safety chapter.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Level the feet of the appliance
to stabilize it. Refer to "Levelling
feet", or the separate Assembly
Instructions.
Close the door. Refer to "Door
open alarm".
Refer to "Replacing the lamp".
Refer to "Operation" chapter.
Wait some hours and then check
the temperature again.
Refer to climate class chart on the
rating plate.
Allow food products to cool to
room temperature before storing.
Refer to "Closing the door".
18
Solution

Publicité

Table des Matières
loading

Table des Matières