EINHELL BM190 Mode D'emploi page 13

Anleitung BM 190-12 sprachig
Electric installation work, repairs and
maintenance are to be carried out only by
specialists.
All guards and safety devices have to be refitted
immediately after completion of any repairs or
maintenance.
It is imperative to observe the manufacturer's
safety, operating and maintenance instructions
as well as the dimensions quoted in the
technical data.
It is imperative to observe the accident
prevention regulations in force in your area as
well as all other generally recognized rules of
safety.
Note the information published by your
professional associations (VBG 7j).
Switch on the dust extraction system each time
you use the machine.
Use the saw only with a suitable vacuum
extraction system or a standard industrial
vacuum cleaner in order to prevent injuries
caused by flying pieces of wood.
I
Wear goggles
N
Wear ear-muffs
L
Wear a breathing mask
Noise emission values
The saw's noise is measured in accordance with
DIN EN ISO 3744; 11/95, DIN EN ISO 11201;
6/96, ISO 7960 Annex J; 2/95. The machine may
exceed 85 dB(A) at the workplace. In this case,
noise protection measures need to be
introduced for the user (ear-muffs).
Sound pressure level LPA
Sound power level LWA
16.10.2001 10:31 Uhr
„The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immision level
at the workplace include the duration of impact, the
type of room, and other sources of noise etc., e.g.
the number of machines and other neighbouring
operations. Reliable workplace values may also vary
from country to country. With this information the
user should at least be able to make a better
assessment of the dangers and risks involved."
5. Technical data
Voltage:
Power:
Idle speed:
Blade length:
Blade speed:
Cutting height:
Throat:
Table size:
Tilting range of table:
Dimensions when assembled: 430 x 305 x 670 mm
6. Before starting
Make sure the machine stands securely, i.e. bolt
it to a workbench or solid base. There are two
holes for this purpose in the machine foot.
All the covers and safety devices have to be
properly fitted before the machine is switched
on.
It must be possible for the saw blade to run
freely.
When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws etc.
Before you actuate the On/Off switch, make sure
that the saw blade is correctly fitted and that the
Cutting Idling
machine's moving parts run smoothly.
Before you connect the machine to the power
88 dB(A) 74 dB(A)
supply, make sure the data on the rating plate is
97 dB(A) 83 dB(A)
the same as that for your mains.
Seite 13
230 V ~ 50 Hz
n0: 1300 rpm
1524 mm
820 m/min.
85 mm / 90°
48 mm / 45°
290 x 290 mm
0° to 45°
(Figure 1)
GB
350 W
190 mm
13