Disconnecting; Re-Establishing A Connection - Sentiotec wave.com4 sound Instructions De Montage Et Mode D'emploi

Instructions for use

5.6. Disconnecting

You have the following options for disconnecting the Bluetooth connection be-
tween your audio source (mobile phone, tablet, etc.) and the Bluetooth module:
● Turn off the Bluetooth function of the audio source.
● Disconnect the connection manually on the audio source. Observe the
information in the operating instructions for your device.

5.7. Re-establishing a connection

The Bluetooth connection between the audio source and the Bluetooth module
is automatically re-established when
● The audio source was outside the range of the Bluetooth module.
● The Bluetooth function of the audio source was turned off and you turn
it back on again.
● The audio source was turned off and you turn the device back on again.
If you have manually disconnected the Bluetooth connection between the audio
source and Bluetooth module at the audio source, you must manually re-establish
the Bluetooth connection to the audio source:
● Choose "wave.com sound" from the list of paired devices.
Making or receiving a call during music playback
If you dial a number or receive a call, the music will automatically pause
and resume again after the phone call.
Since the Bluetooth module does not have a microphone, you have to
switch the sound to your mobile phone. Observe the information in the
operating instructions for your device.
WORLD OF WELLNESS
p. 12/18