Turning Corners - Janome 1200D PROFESSIONAL Manuel D'instructions

Masquer les pouces Voir aussi pour 1200D PROFESSIONAL:
Table des Matières

Publicité

Turning Corners

Sew to the turning point and stop with needles up.
Hand turn the handwheel towards you to bring needles
to the lowest position into the fabric. Carefully turn the
handwheel in reverse bringing needles to the highest
position. (This releases the needle threads off the
looper.) Raise the presser foot, turn the fabric, lower
the needles into the fabric, lower the presser foot and
continue sewing.
The looper thread will drop at the corner. Use a hand
needle and thread to prevent the loop from unraveling.
Pull the diagonal thread to corner (a).
Turn fabric over and secure loop to corner on the
underside.
100

Publicité

Table des Matières
loading

Table des Matières