GUTMANN Adelante 515 Notice De Montage page 16

en
4. Attach tower angle bracket (for attaching
the upper tower) to the wall.
5. Screw machine screws into the screw
anchors (Ø10 mm) until they protrude by
about 20 mm.
6. Hang the exhaust hood and loosely tighten
it with the washers and nuts.
7. Align the exhaust hood (inspect the
installation) and tighten the nuts.
8. If necessary, secure the exhaust hood with
two additional screws.
9. (Exhaust operation) Cut the exhaust hose
to the proper length.
10. (Exhaust hose) Attach and tighten the
exhaust hose, be sure that it is free of bends.
11. Create the electrical connection. (Exhaust
operation) Connect an extension cable if an
external blower motor is to be used.
12. Bend the retaining grooves on the upper
tower outwards approximately 2-3 mm.
13. Slide the upper tower into the retaining
tongue on the tower mount until it clicks into
place.
14. Pull the under tower slightly outwards and
place the upper tower and the exhaust hood
module on it. The under tower must be
touching the hood.