Filling The Tank; Detergent/ Chemical Tank; Operation; A - Checks Before Use - Ghibli & Wirbel RUNNER R 150 FD 85 Utilisation Et Entretien

www.ghibliwirbel.com
Professional Cleaning Machines Since 1968

9.1 - FILLING THE TANK

(Fig. 1-12)
WARNING:
Only add clean mains water to the tank at
a temperature no greater than 50°C.
- Check that the hose (17) is properly con-
nected to the tank by means of the appro-
priate joints.
- Open the clean water tank (13) cap (14).
- Pour water into the tank (13) until it is full.
- Close the cap (14) when the filling proce-
dure is completed.
9.2 - DETERGENT/
CHEMICAL TANK
(Fig. 13)
NOTE:
Use non-foamy detergents only. For the
quantities, follow the instructions provided by
the detergent manufacturer according to the
type of dirt.
DANGER:
- In the event of eye or skin contact with
the detergent, or ingestion of the de-
tergent, see the detergent manufactur-
er's usage and safety data sheet.
- Lift the lever (52) to unlock the cover (53),
then lift it.
- Check that in the tank (54) there's the
product necessary for the working day.
In case of tank replacement work as indicate
below:
- Remove the cap (55), extract the tank
(54) and insert a new 5 litres one then in-
sert the cap (55) using the small suction
pipe.
NOTE:
The tanks (54) to use are the standard 5 li-
tres type which can be found on the market.
- Close the cover (53) and block it with the
coupling (52).
- Perform the air purging procedure (de-
scribed in this manual).

10.1 - OPERATION

10.1.a - Checks before use

- Check that the recovery tank's drain-
age tube (15) is properly connected and
sealed.
- Check that the squeegee's water suction-
ing tube (16) is properly inserted into the
recovery tank.
- Check that the coupling (56) on the
squeegee (20) is not obstructed and that
the tube is properly connected.
- Check the charge status of the batteries
by turning the key (29) to its "ON" position
and checking the charge indication on the
display (38).
10.1.b - Preparing the machine and
choosing the cycle (Fig. 9-10)
- Sit on the driving position.
Working cycle:
- The machine can perform 4 working cy-
cles:
Drying only cycle:
- To perform only the drying cycle press
the "
rator activates.
Brushing only cycle:
- To perform only the brushing cycle press
ON/OFF
the " " button (43 Fig. 9), the brushes
rotation is prepared.
Brushes rotation starts when the ma-
chine, with the accelerator (7 Fig. 10)
pressed, starts moving forward or back-
ward, or with the accelerator pressed an
potentiometer (30) turned on "0".
Washing, brushing cycle:
- Press the button "
pare brushes rotation and press the but-
ENGLISH - 15
(Fig. 1-7-9)
" button (40 Fig. 9), the aspi-
ON/OFF
" (43 Fig. 9) to pre-