Audio Adjust - Pioneer FS-W40 Mode D'emploi

> Before Start > Part Names
■ Information
Transmission Status This indicates the communication status of the sound system
controller.
Front Left The connection status of the front left speaker is displayed.
"---": Not paired
"Connected": Successfully connected
Front Right The connection status of the front right speaker is displayed.
"---": Not paired
"Connected": Successfully connected
Surround Left The connection status of the surround left speaker is displayed.
"---": Not paired
"Connected": Successfully connected
Surround Right The connection status of the surround right speaker is displayed.
"---": Not paired
"Connected": Successfully connected
Subwoofer The connection status of the subwoofer is displayed.
"---": Not paired
"Connected": Successfully connected
■ Subwoofer
Subwoofer Set whether a subwoofer is connected or not.
"Yes (Default Value)": When using a subwoofer
"No": When not using a subwoofer
16
> Install > Setup > Playback
Supplementary information | Firmware Update | Others

Audio Adjust

■ Dual Mono / Mono
Dual Mono Set the audio channel or language to be output when playing
multiplex audio or multilingual TV broadcasts etc.
"Main (Default Value)": Main channel only
"Sub": Sub channel only
"Main / Sub": Main and sub channels will be output at the same
time.
0 If multiplex audio is being played, "1+1" will be displayed on
the display of the sound system controller when
remote controller is pressed.
Mono Input Channel Set the input channel to use for playing any 2 ch digital source
such as Dolby Digital, or 2 ch analog/PCM source in the Mono
listening mode.
"Left": Left channel only
"Right": Right channel only
"Left + Right (Default Value)": Left and right channels
■ Dolby
Loudness When playing Dolby TrueHD, enable the dialog normalization
Management function which keeps the volume of dialog at a certain level. Note
that when this setting is Off, the DRC function that allows you to
enjoy surround at low volumes is fixed to off when playing Dolby
Digital Plus/Dolby TrueHD.
"On (Default Value)": Use this function
"Off": Do not use this function
■ Volume
Volume Limit Set the maximum value to avoid too high volume. Select "Off
(Default Value)" or a value between "30" and "49".
E
N
on the