System Setup - Pioneer FS-W40 Mode D'emploi

> Before Start > Part Names

System Setup

1
The unit allows you to configure advanced settings to provide you with an even better
experience.
1. Switch the input on the TV to that assigned to the unit.
2. Press on the remote controller.
3. After the System Setup screen is displayed, select the content with
remote controller and press ENTER to confirm your selection.
System Setup
0 Change the initial values for each of the settings with the cursors  /
14
> Install
2
/
TV Out
Wireless Speaker Hardware
.
> Setup > Playback
0 To return to the previous screen, press
4. To exit the settings, press
TV Out
■ TV Out / OSD
1080p -> 4K Upscaling When using a TV that supports 4K, video signals input at 1080p
Super Resolution
OSD Language
Impose OSD
/  / on the
Screen Saver
Supplementary information | Firmware Update | Others
.
.
can be automatically upscaled to 4K for output.
"Off (Default Value)": When not using this function
"Auto": Use this function
0 Select "Off" if your TV does not support 4K.
When you have set "1080p -> 4K Upscaling" to "Auto", you can
select the degree of video signal correction from "Off" and
between "1" (weak) and "3" (strong).
Select the on-screen display language.
English, German, French, Spanish, Italian, Dutch, Swedish,
Russian, Chinese
Set whether or not to display the information on the TV when the
volume is adjusted or input is changed, for example.
"On (Default Value)": OSD displayed on the TV
"Off": OSD not displayed on the TV
0 OSD may not be displayed depending on the input signal
even if "On" is selected. If the operation screen is not
displayed, change the resolution of the connected device.
Set the time to start the screen saver.
Select a value from "3 minutes (Default Value)", "5 minutes", "10
minutes" and "Off".
E
N