Standard Surround Setup - Pioneer S-FCR3700 Mode D'emploi

SURROUND SPEAKERS
For best results the loudspeakers should be positioned at or
above ear level. Depending upon your room layout and
preferences, the left and right rear speakers should be
positioned on the side walls just the rear of the listening
position, or on the walls.
SUBWOOFER
Sound spreads in all directions in the very low frequency
range. Human hearing cannot easily detect the source of very
low frequencies. Be sure to provide a space of at least 8 inches
(20cm) between the rear of the subwoofer and the nearest
wall.

STANDARD SURROUND SETUP

This is a standard multichannel surround sound speaker
setup for optimal 5.1 channel home theater sound.
Center
Front left
Listening position
Surround
left
Assembling the speaker stand bases and
securing your front speakers
(S-FCR3700 only)
Attach the speaker stand bases to the stems using the screws
provided.
Once you have aligned the stem and base, secure with the
small screws at the points shown below. Note that the speaker
should face in the direction of the base of the isosceles
triangle (outlined below).
Rear
Front
Front right
Subwoofer
Surround
right
Secure each of the front speakers using the plastic catch
provided.
Screw two picture hooks or similar into the wall behind the
speaker. Pass a cord around the hooks and through the
plastic catch so that the speaker is stabilized (make sure to
test that it supports the weight of the speaker).
After installing, make sure the speaker is securely fixed.
Caution
• The plastic catch is not a mounting fixture, and the
speaker should not be hung directly from the wall using
this catch. Always use a cord when stabilizing the speaker.
• Pioneer disclaims all responsibility for any losses or
damage resulting from improper assembly, installation,
insufficient strength of the installation materials, misuse,
or natural disasters.
• Do not stand on the speaker stand base of the tall speaker
to push or swing the speaker. The speaker may fall and
break, or someone may be injured. Pay special attention to
children.
NON-SKID PADS
S-FCR3700:
Attach the small non-skid pads to the base of the surround
and center speakers. The large non-skid pads are for the front
speakers (as shown).
Use the adhesive side of the pads to attach them to the base
of each speaker.
If you choose to use speaker stands with the surround
speakers, attach the non-skid pads to the stand bases instead
of to the underside of the speakers.
Small non-skid pads
Center speaker
Surround speakers
Large non-skid pads
Front speakers
Sufficiently thick
cord (not supplied)
Plastic catch
Speaker stands
3
En