Pioneer S-FCR3700 Mode D'emploi

S-FCR3700
S-FCR3300
S-W3700
WHAT'S IN THE BOX
• S-FCR3700
• Front speakers x 2 • Surround speakers x 2
• S-FCR3300-K
• Front speakers x 2
• Surround speakers x 2
• S-W3700-K
• Subwoofer
Important
The serial number for this equipment is located on the side of
the packing case. Please write this serial number on the
warranty page and keep it in a secure area for future reference.
WARNING: Handling the cord on this product or
cords associated with accessories sold with the
product will expose you to chemicals listed on
proposition 65 known to the State of California and
other governmental entities to cause cancer and
birth defect or other reproductive harm.
Wash hands after handling
-K
-K
• Center speaker
• Speaker stand bases x 2
• Speaker stands x 2
• Center speaker x 1
• Non-skid pads x 20 (1 set)
Subwoofer (Purple)
• Speaker cord
• Non-skid pads (large) x 4
D36-P4_A_En
http://www.pioneerelectronics.com
Operating Instructions
Front right (Red)
Surround right (Grey)
• Speaker cords x 5
• Non-skid pads (small) x 12
• Non-skid pads (large) x 8
Front right (Red) Front left (White)
Surround right (Grey)
• Speaker cords x 5
• Operating guide
BEFORE USE
Thank you for buying this Pioneer product.
Please read through these operating instructions before using
your speaker system to optimize performance.
• The nominal impedance of this speaker system is
8 Ω. Connect the speaker system to an amplifier with a
load impedance ranging from 4 Ω to 16 Ω (a model with "4
Ω to 16 Ω" displayed on the speaker output terminals).
In order to prevent damage to the speaker system
resulting from input overload, please observe the following
precautions:
• When connecting or disconnecting cables, be sure
amplifier power is OFF.
• Do not use excessive amplifier volume if using a tone
control to emphasize high or low frequencies.
Speaker System
Front left (White) Center (Green)
Surround left (Blue)
• Screws (for bases) x 6
• Screws
(for speaker stand) x 2
Center (Green)
Surround left (Blue)
1
En