Pioneer FS-W40 Mode D'emploi page 50

> Before Start > Part Names
0 "Completed!" is displayed when the update is complete.
9. Remove the USB storage device from the sound system
controller.
10.Press Í/l on the sound system controller to turn the unit
into standby mode. The process is completed and your
firmware is updated to the latest version.
0 Do not use Í on the remote controller.
If an error message is displayed: When an error occurs,
" ＊ - ＊＊ Error!" is displayed on the display of the sound
system controller. (" ＊ " represents an alphanumeric
character.) Check the following:
0 ＊ -01, ＊ -10: USB storage device not found. Check
whether the USB storage device or USB cable is
correctly inserted to the USB port of the sound system
controller.
Connect the USB storage device to an external power
source if it has its own power supply.
0 ＊ -05, ＊ -13, ＊ -20, ＊ -21: The firmware file is not
present in the root folder of the USB storage device, or
the firmware file is for another model. Retry from the
download of the firmware file.
0 Others: Disconnect then reconnect the AC power cord,
then repeat from the beginning.
> Install > Setup > Playback
Supplementary information | Firmware Update | Others
E
N
49