Connect The Tv - Pioneer FS-W40 Mode D'emploi

> Before Start > Part Names

2. Connect the TV

1
a HDMI cable, b Digital optical cable
> Install
DIGITAL
OPTICAL OUT
b
> Setup > Playback
a
Supplementary information | Firmware Update | Others
To ARC TV
For a TV that supports the ARC (Audio Return Channel)
feature, use an HDMI cable and connect according to
illustration "a". Choose an HDMI IN jack on the TV that
supports ARC when connecting.
To Non-ARC TV
For a TV that does not support the ARC (Audio Return
Channel) feature, connect both the HDMI cable in illustration
"a" and the digital optical cable in "b". If the TV doesn't have
a DIGITAL OPTICAL OUT jack, use an analog audio cable
and connect the TV's ANALOG AUDIO OUT jack to the
AUDIO IN jack on the sound system controller.
Connection with a digital optical cable or analog audio cable
is not necessary if you will watch TV through a device such
as a cable set-top box (that is, not use a tuner built into the
TV) that you have connected to the HDMI IN jack on the
sound system controller.
Setup
0 Settings are required to use the ARC function. Make
settings after all connections are complete. Settings are
made in the System Setup ( P14) menu displayed by
pressing on the remote controller. The ARC function is
enabled by setting "Hardware" - "HDMI CEC" (
the System Setup menu to "On".
0 Please refer to the TV's operation manual for directions
on connections and setup for the TV.
E
N
P17) in
9