Comfort Adjustments - Vermeiren Inovys II + L70 Manuel D'utilisation

3.3

Comfort adjustments

3.3.1 Backrest and seat inclination
The seat inclination and backrest inclination can be adjusted
simultaneously or separately by an attendant. Make sure that the
patient sits in the chair when the attendant adjusts the backrest
inclination and that the wheelchair does not tip over.
Seat inclination:
1. Squeeze the lever (3) on the left handle (see label)
towards the handle to adjust the seat inclination.
2. Pull/Push the seat in the desired position (0° to + 30°), the gas pressure spring shall
be pressed in/out.
3. Loosen the lever (3) to block the gas pressure spring.
Backrest inclination:
1. Squeeze the lever (3) on the right handle (see label) towards the handle to adjust
the angle of the backrest.
2. Pull/Push the backrest in the desired position (0° to + 45°), the gas pressure spring
shall be pressed in/out.
3. Loosen the lever (3) to block the gas pressure spring.
3.3.2 Leg rest inclination
The leg rest is adjustable in 6 positions.
1. Slightly loosen the star knob (4) on both sides of the leg rest.
2. Lift/Lower the leg rest until the desired angle is reached.
3. Tighten the star knobs (4) again firmly.
3.3.3 Footplate angle
The footplate is adjustable in 3 positions.
1. Slightly loosen the star knob (5) on both sides of the footplate.
2. Turn the footplate up/down until the desired angle is reached.
3. Tighten the star knobs (5) again firmly.
3.3.4 Headrest
The headrest is fully adjustable in height and angle. To alter
the position of the headrest: loosen any lever/star knob as
specified below, adjust the headrest to the desired position,
and retighten firmly.
[6] To adjust the headrest sideways.
[7] To rotate the headrest (360°).
[8] To adjust the headrest forward/backward.
[9] To adjust the height of the headrest.
To remove the headrest, loosen lever (9) and lift the
headrest out of the support.
7
Inovys II + L70
2022-01
Using your wheelchair
3
4
5
6
8
9
EN
NL
7