Balanced Body Allegro 2 Instructions D'utilisation page 15

Instructions for Allegro® 2 Reformer
Options and Accessories
INCLUDES INSTRUCTIONS FOR ALLEGRO 2:
» Foot Plate (jumpboard)
» Foot Strap
» Extended Legs
» Wheel Kit
» Wall Security Strap
» Tower Mat Conversion
» 4th Side for Tower Push-thru Bar
I. INSTALLING THE FOOT PLATE (JUMPBOARD)
Before installing the footplate,
position the footbar at the
lowest position and closest
to the spring end of the
Reformer, so that the footplate
won't touch the footbar when
installed. Support of the
footbar is not required on the
Allegro 2. To use the footplate,
slide the posts into the
receivers until the foot plate
rests on the standing platform.
See Fig B.
Page 15
Page 15
Page 16
Page 17
Page 18
Page 18
Page 18
Figure B
II. INSTALLING THE ALLEGRO 2 FOOT STRAP
Feed the loops of the footstrap between the frame and standing
platform, through the footman's loops, and then around the hook
plates on the underside of the standing platform as shown in
Figure C.
Footman's
loop
Figure C: Shown from under Standing Platform.
For a long footstrap, place the
loops around the outer hooks.
For a short footstrap, place the
loops around the inner hooks.
For a medium length footstrap,
place one loop around the
outer hook and the other loop
around the inner hook. See
Figure C.
IMPORTANT SAFETY TIP:
The foot strap must be
checked for proper installation
before each use. An improperly
installed foot strap can lead to
serious injury.
Inner hook
Outer hook
Footstrap
Figure D: Footstrap shown from top of
standing platform.
14