Miele MF03 10 Notice De Montage page 7

Produktgruppe 512
7 von 42
Danger!
Even with the machine switched off, mains voltage may be applied to some components.
Before any service work is commenced, the machine must be disconnected from the mains. Suitable measurements must be made to
ensure that this is the case.
A general visual check and risk evaluation should always be carried out.
Incorrect conversion or service work can be dangerous (risk of fire, electric shock, etc.).
Danger!
Correct earthing function can be deactivated if casing parts are incorrectly assembled.
Correct earthing function must be ensured when refitting the casing.
Carry out appropriate electrical safety checks.
Danger!
During fitting, all accessible conductive parts that are not connected to the earth must not have any link to earth (strengthened double
insulation).
To confirm this, insulation resistance and touch current measurements must be carried out.
Note
The kit, Mat. no. 09079460, for PW 6107, PW 6137, PW 6167 and PW 6207 contains the following:
1 electronic module EZL 235, module 3 (liquid dispensing 7 - 11 and WRG (water recycling))
4 spacers (for electronic module EZL 235 fastening)
1 coding plug MFM 3-5 (module 3 EZL 235 - Plug connector ST3), PIN 3-5
1 coding plug WRG 1 (module 3 EZL 235 - Plug connector ST6), PIN 2-3
1 coding plug MFM 53X (module 3 EZL 235 - Plug connector ST7), PIN 1-2, 3-4
1 plug N1Q-ST11A (module 3 EZL 235 - Plug connector ST11), PIN 1-2
1 wiring harness 20X-41X (module 3 EZL 235 - Plug connector ST10 / modul 1 EZL 235 - Plug connector ST9), plug housing,
3-pole, 500 mm
1 wiring harness N1Q_ST112, N1Q_ST11 (module 3 EZL 235 - Plug connector ST111 / module 1 EZL 235 - Plug connector
ST112), plug housing, 4-pole, 350 mm
3 connection wires, black 0.75 x 90
1 screw connector strip, 4-pole, neutral
1 screw connector strip, 4-pole, red
1 screw connector strip, 6-pole, blue
1 screw connector strip, 7-pole, green
1 terminal strip 1X3-4, orange
1 terminal strip 2X3-4, grey
1 terminal strip 3X3-4, blue
1 terminal strip 4X3-4, green/yellow
1 liquid dispensing accessory
1 wiring diagram PW 6107 - PW 6207 module 2, Mat. no. 09082720
Fitting instructions - Module 3, liquid dispensing 7 - 11 and water recycling (WRG), Mat. no. 09087201.
06.02.2014 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 09087201