Pioneer XC-HM82-K Mode D'emploi page 28

9
9
5
Press the ENTER button.
Press WPS Button on
Device to Be Connected
[ENTER] Start
6 Wait a few minutes until the connection is completed.
Select WPS Method
PBC (Push Button Configuration)
PIN Input
7
Once the following message is displayed, press the
ENTER button.
Connection Successful
[ENTER] OK
28
8
Press the NET SERVICE button, and select Internet Radio.
Confirm that the Wi-Fi operation mark has changed to
Internet Radio
Top Menu
Genres
Countries
Podcasts By Genre
Podcasts By Location
Note
• If the Wi-Fi operation mark does not change to
receiver only supports names in SSID, that is half width
alphanumeric characters and a selection of certain
symbols such as the underscore. If you have used any other
characters, please change them to SSID prior to
performing network settings. Please see your router's user
manual for details of SSID.
• If the above does not resolve the issue, please refer to the
troubleshooting section (page 46).
• If "Empty" is displayed, there is a possibility that the router
is not connected to the internet. Check whether other
connected devices, such as a computer, are able to use the
internet. If not, connect the router to the internet. Refer to
the router's user manual for details on how to do so.
Network quick setup guide
Connection method 4 | Have the receiver
automatically detect the wireless LAN router and
.
perform settings
1
Press the STANDBY/ON button.
Do not connect a LAN cable to this receiver.
STANDBY/ON
DIMMER
iPod/USB
2
Press the NET SERVICE button, and select Internet Radio.
, the
Confirm that the Wi-Fi operation mark
displayed.
Internet Radio
Top Menu
Empty
3
Press the SETUP button.
Use / and the ENTER button to move through the
layers.
OPEN/CLOSE
TIMER SLEEP
INPUT
CD BT AUDIO SOUND
or is