Listening To Auxiliary Component; Headphones; Sound Controls - Pioneer XC-HM82-K Mode D'emploi

3
3

Listening to auxiliary component

1
Press AUDIO IN to select Audio In.
Audio In is shown on the display.
Audio In
2 Start playback of the auxiliary component.

Headphones

• Do not turn the volume on to full at switch on and listen to
music at moderate levels. Excessive sound pressure from
earphones and headphones can cause hearing loss.
• Before plugging in or unplugging the headphone, reduce
the volume.
• Be sure your headphone has a 3.5 mm (3/16 in.) diameter
plug and impedance between 16 and 50 ohms. The
recommended impedance is 32 ohms.
• Plugging in the headphone disconnects the speakers
automatically. Adjust the volume using the VOLUME
control.
Display brightness control
Press DIMMER button to dims the display brightness. The
brightness can be controlled in four steps.
Auto volume
If you turned off this receiver with the volume set to 41 or
higher, the volume starts at 40 when the receiver turns on next
time.
Volume control
Turn the volume (on this receiver) or press VOLUME +/– (on
remote control) to increase or decrease the volume.
CAUTION
• The sound level at a given volume setting depends on
speaker efficiency, location, and various other factors. It is
advisable to avoid exposure to high volume levels. Do not
turn the volume on to full at switch on. Listen to music at
moderate levels. Excessive sound pressure from earphones
and headphones can cause hearing loss.
Muting
The volume is muted temporarily when pressing the MUTE
button on the remote control. Press again to restore the
volume.

Sound Controls

P.Bass control
When the P.BASS button on the remote is pressed, the P.Bass
mode turns ON and powerful music emphasizing low bass
can be enjoyed. To cancel the P.Bass mode, press the P.BASS
button.
Bass control
Press the BASS button, then press / to adjust the bass.
Treble control
Press the TREBLE button, then press / to adjust the
treble.
Getting started
Equaliser
When the SOUND button is pressed, the current mode setting
will be displayed. To change to a different mode, press the
SOUND button repeatedly to select the desired sound.
No equalization.
FLAT Equaliser off.
For rock music.
GAME For game.
For classical music.
CLASSIC
For classical music.
For pop music.
POPS For pop music.
Vocals are enhanced.
VOCAL Vocals are enhanced.
For jazz.
JAZZ For jazz.
13