Table des Matières
Publicité
1 Ignition coil lead
2 Clamp
3 CDI magneto lead
4 Neutral switch lead (except for
USA and CDN)
5 Radiator breather hose
6 Connector cover
A Clamp the ignition coil lead to
the frame at its locating tape.
Clamp it in front of the radiator
fitting boss.
CABLE ROUTING DIAGRAM
B Clamp the CDI magneto lead to
the frame at its locating tape.
Clamp it at the rear of the radia-
tor fitting boss.
C Do not allow the neutral switch
lead to slacken except over the
radiator hose. (except for USA
and CDN)
D Pass the neutral switch lead
through the holder. (except for
USA and CDN)
E Pass the radiator breather hose
outside the engine bracket and
inside the down tube. Then
pass the radiator breather hose
inside the CDI magneto lead.
F Clamp the CDI magneto lead,
radiator breather hose, YPVS
breather
hose
and
switch lead (except for USA and
2-15
SPEC
CDN) to the frame.
G Clamp the radiator breather
hose, CDI magneto lead and
neutral switch lead (except for
USA and CDN) to the frame.
H Pass the CDI magneto lead,
radiator breather hose and neu-
tral switch lead (except for USA
and CDN) in front of the radiator
hose. Then pass the radiator
breather hose inside the CDI
magneto lead.
I Pass the radiator breather hose
and ignition coil lead between
the frame and the radiator (left).
J Locate the clamp ends in the
arrowed range.
K Bring the connector cover into
neutral
contact with the coupler.
Publicité
Table des Matières
