JVC KD-DB97BT Manuel D'instructions page 21

AUDIO SETTINGS
Speaker output settings
(Only for X ' OVER 2-WAY)
Select the output setting for the speakers [SPK/PRE OUT], base on the
speaker connection method.
Connection via lineout terminals
For connections through an external amplifier. ( 29)
Audio signal through lineout terminal
Setting on
[SPK/PRE OUT]
FRONT
REAR/REAR Front speakers
(default) output
SUB.W/SUB.W Front speakers
output
Connection via speaker leads
For connections without using an external amplifier. However, with this
setting you can also enjoy the subwoofer output. ( 29)
Setting on
[SPK/PRE OUT]
REAR/REAR Rear speakers output
SUB.W/SUB.W Subwoofer output
If [SUB.W/SUB.W] is selected:
– [HIGH 120HZ] is selected in [SUB.W LPF] and [THROUGH] is not available.
– [R02] is selected in [FADER] and selectable range is [R15] to [00].
REAR
Rear speakers output Subwoofer output
L (left): Subwoofer output Subwoofer output
R (right): (Mute)
Audio signal through rear speaker lead
L (left) R (right)
Rear speakers output
(Mute)
Crossover settings
Below are the available setting items for 2-way crossover and 3-way
crossover.
Caution
Select a crossover type according to how the speakers are connected.
( 29)
If you select a wrong type:
• The speakers may damage.
• The output sound level may be extremely high or low.
SW
SPK SIZE (speaker size)
Selects according to the connected speaker size for optimum
performance.
• The frequency and slope settings are automatically set for the
crossover of the selected speaker.
• If [NONE] is selected for [TWEETER] of [FRONT], [REAR] and [SUBWOOFER] for
[SPK SIZE], the [X ' OVER] setting of the selected speaker is not available.
X ' OVER (crossover)
[FRQ]/ [HPF FRQ]/ [LPF FRQ]:
Adjusts the crossover frequency for the selected speakers (high pass
filter or low pass filter).
• If [THROUGH] is selected, all signals are sent to the selected speakers.
[SLOPE]/ [HPF SLOPE]/ [LPF SLOPE]:
Adjusts the crossover slope.
• Selectable only if a setting other than [THROUGH] is selected for the
crossover frequency.
[PHASE]:
Selects the phase of the speaker output to be in line with the other
speaker output.
[GAIN LEFT]/ [GAIN RIGHT]/ [GAIN]:
Adjusts the output volume of the selected speaker.
19
ENGLISH