Environmental Protection - Worx VERSACUT WX420 Notice Originale

TROUBLESHOOTING
Symptom
tool will not start when
operating the on/off switch.
Cutting depth is less than that
is set.
Blade spins or slips.
Blade will not cut a straight line.
Blade kicks back when
beginning a cut..
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or retailer for
recycling advice.
Mini circular saw
Possible Causes
Power cord not plugged in.
Power cord is broken.
Carbon brush has worn
down.
Sawdust accumulated at the
rear of the base.
Blade is not tightly engaged
with the spindle.
Blade is dull.
Blade is not mounted
properly.
Saw is not being guided
properly.
Blade is not spinning fast
enough
Possible Solution
Check to make sure power cord
is connected well into a working
outlet.
Unplug the power cord. Replace
it using a qualified maintenance
person.
Replace the carbon brush using a
qualified maintenance person.
Shake out sawdust. Consider
connecting a vacuum for dust
collection.
Remove the blade, and
reassembled it as described in
INSTaLL/CHaNGE THE BLaDE
section.
Mount a new, sharp blade on the
saw.
Check that blade is properly
mounted.
Use an edge guide.
Allow the saw blade to reach full
speed prior to beginning a cut.
15
EN